User`s manual

5.8 R.E.T.R.
5.8 R.E.T.R.
Before activating the R.E.T.R. function, please set the detection area and activate the motion
detection function first.
There are three ways to activate the Remote Event Trigger Recording function.
1) DVR Front Panel:
Press “Menu” + “－” buttons on the DVR front panel. And R.E.T.R. function will be activated
3 / 5 / 10 minutes later.
Please refer to
Please refer to
“
“
Section 4.11
Section 4.11
”
”.
When the R.E.T.R. is activated, the red “R.E.T.R” OSD will be shown on the screen.
2) Licensed Software AP:
Press “R.E.T.R.” button on the AP control panel to activate the R.E.T.R. function
immediately.
Please refer to
Please refer to
“
“
Section 5.6
Section 5.6
”
”
.
.
3) IR Remote Control:
Press “R.E.T.R.” button on the IR remote control to activate the R.E.T.R. function for 3 / 5 /
10 minutes later.
Please refer to
Please refer to
“
“
Section 4.11
Section 4.11
”
”
.
.
5.9 OPTIONAL PERIPHERALS
5.9 OPTIONAL PERIPHERALS
1) IDA (independent disk array).
2) VGA connector.
3) For 4CH DVR, IR Remote Control is optional.
For the operation of the following peripherals, please refer to their manual individually.
48