User`s manual

4.12 ADVANCE MENU___NETWORK

Move the cursor to “NETWORK”, press ”ENTER”, and the screen will show the

following options.

1) NETWORK TYPE (STATIC):

Select NETWORK TYPE, press “＋”or “－” button to set the network type as

STATIC, and then press “ENTER” to go to the submenu of the network. In

the submenu of the network type, use “＋”or “－” button to set all the

information needed in the DVR. See the illustration below.

2) NETWORK TYPE (DHCP):

This DHCP function needs to be supported by a router or cable modem network

with DHCP service. For detailed DHCP settings, please refer to P.37 and P.38

(Licensed Software AP).

3) NETWORK TYPE (PPPoE):

This PPPoE function needs to have “username” and “password” subscribed from

one ISP supplier. For detailed PPPoE settings, please refer to P.37 and P.38

(Licensed Software AP).

NOTE:

DHCP and PPPoE network types need to apply DDNS service to get “Hostname” to

correspond to the dynamic IP address. For detailed DDNS settings, please refer to P.38.

NETWORK

NETWORK TYPE STATIC

DNS 168. 95. 1. 1

PORT 0 0 8 0

STATIC

IP 60

. 121. 46. 236

GATEWAY 60. 121. 46. 226

NETMASK 255. 255. 255. 254

11) LANGUAGE (support multi-language):

Press “ENTER”, and select the language of the OSD.

12) VERSION:

The firmware version information will be shown on the screen.

13) VIDEO FORMAT:

The information of the DVR’s video format will be shown on the screen.