User`s manual

23
4.10 ADVANCE MENU ___REMOTE
4.10 ADVANCE MENU ___REMOTE
Move the cursor to “REMOTE”, press ”ENTER”, and the screen will show the
following options.
REMOTE
REMOTE
TITLE DEVICE ID PROTOCOL RATE
01 PTZ 001 P - D 02400
02 CAMERA 002 NORMAL 02400
03 CAMERA 003 NORMAL 02400
04 CAMERA 004 NORMAL 02400
05 CAMERA 005 NORMAL 02400
06 CAMERA 006 NORMAL 02400
07 CAMERA 007 NORMAL 02400
08 CAMERA 008 NORMAL 02400
PREV NEXT
1) TITLE:
Title of each camera.
2) DEVICE:
Select to control a normal camera or PTZ camera for each channel.
3) ID:
Set the ID number (0 ~ 255) of the PTZ camera.
Note: After connecting to a PTZ camera correctly, the default ID of the PTZ camera will
be shown on the screen
.
Note: Please refer to the instruction “PTZ Connection and Control” below.
4) PROTOCOL:
Select NORMAL (our protocol) or PELCO-D protocol.
5) RATE:
Set the baud rate of each channel (2400, 4800, 9600, 19200, 57600). For the
connected cameras, such as PTZ and speed dome cameras, etc., please make
sure the baud rate setting is the same as the setting here.
***PTZ Connection and Control: ***
***PTZ Connection and Control: ***
1)
1)
Device
Device
: Our own brand PTZ / Pelco-D protocol PTZ
2)
2)
Connection
Connection
: For detailed connection and instructions, please refer to your PTZ
camera manual.
Note:
Note:
As for “RS485A and RS485B Port” connection, please refer to
“Section 1.5 Rear
Panel”, or refer to “Appendix #2 PIN Configuration”.
3)
3)
Control Mode
Control Mode
: Refer to the front panel or your IR remote control manual.
Take 16CH as an example
Take 16CH as an example