User`s manual

47
6.9 GPRS
6.9 GPRS
6.8 R.E.T.R.
6.8 R.E.T.R.
Before you activated the R.E.T.R. function,
please set the detection area and activated the motion detection function first.
There are three way to activate the Remote Event Trigger Recording function.
1) DVR Front Panel:
Press “Menu” + “ ” buttons on the DVR front panel. And R.E.T.R. function will
activate 3 / 5 / 10 minutes later.
Please refer to
Please refer to
“
“
Section 5.12
Section 5.12
”
”.
When the R.E.T.R. is activated, the red “R.E.T.R” OSD will shown on the screen.
2) Licensed Software AP:
Press “R.E.T.R.” button on the AP control panel to activate the R.E.T.R. function
immediately.
Please refer to
Please refer to
“
“
Section 6.6
Section 6.6
”
”
.0
.0
3) IR Remote Control:
Press “R.E.T.R.” button on the IR remote control to activate the R.E.T.R. function 3 / 5 /
10 minutes later.
Please refer to
Please refer to
“
“
Section 5.12
Section 5.12
”
”
.
.
6.10 OPTIONAL PERIPHERALS
6.10 OPTIONAL PERIPHERALS
1) IDA (independent disk array).
2) DVD R/W or CD R/W backup.
3) VGA output.
4) GPRS connector.
For the operation of the following peripherals, please refer to their manual individually.
GPRS function Installation and Viewing (Take
GPRS function Installation and Viewing (Take
Motorola
Motorola
768i for example)
768i for example)
1) Your mobile service provider must have GPRS service, and the phone handset needs to
support GPRS and Java MIDP 2.0 to run the application.
2) Connect to the website http://211.22.74.18 via the web browser of your cell phone.
(Make sure that your GPRS function is working).
3) Download and install
“
“
16CH_MPEG
16CH_MPEG
-
-
4
4
”
”
/
/
“
“
8CH_MPEG
8CH_MPEG
-
-
4
4
”
”.
4) After installation, the
“
“
16CH_MPEG
16CH_MPEG
-
-
4
4
”
”
/
/
“
“
8CH_MPEG
8CH_MPEG
-
-
4
4
”
” icon will shown on the desktop of
the phone.
5) Click the icon of the
“
“
16CH_MPEG
16CH_MPEG
-
-
4
4
”
”
/
/
“
“
8CH_MPEG
8CH_MPEG
-
-
4
4
”
” video server to enter the setting
frame.
Please type in IP address, port, username, and password of the DVR, which you like to see.
And then press “connect” button.
6) After connected to the
“
“
16CH_MPEG
16CH_MPEG
-
-
4
4
”
”
/
/
“
“
8CH_MPEG
8CH_MPEG
-
-
4
4
”
” video server, you will see AP
interface shown on the screen and will see “Online” on title.
7) Wait 3 minutes for video signal to coming out.
8) After video signal is shown, you could monitor and control your security system handily
anytime, anywhere.
NOTE
NOTE: It’s not suggested to set the DVR port as 80 port.
Because some telecommunication service provider may regulate 80 port.