User`s manual

5.13 ADVANCE MENU ___NETWORK

11) LANGUAGE:

Press “ENTER”, and select the language of the OSD.

12) VERSION:

The firmware version information will be shown on the screen.

13) VIDEO FORMAT:

The information of the DVR’s video format will be shown on the screen.

Move the cursor to the “NETWORK”, and press ”ENTER”, then the screen will show

the following options.

NETWORK

NETWORK TYPE STATIC

DNS 168. 95. 1. 1

PORT 0 0 8 0

1) NETWORK TYPE (STATIC):

Select NETWORK TYPE, and press “＋” or “－” button to set the network

type as STATIC, and then press “ENTER” to go to the submenu of the

network. In the submenu of network type, use “＋” or “－” button to set all the

information needed in the DVR. See the illustration below.

STATIC

IP 61. 66. 138. 53

GATEWAY 61. 66. 138. 65

NETMASK 255. 255. 255. 0

2) NETWORK TYPE (DHCP):

This DHCP function need to be supported by router or cable modem network with

DHCP service. For detailed DHCP setting, please refer to P.36 and P.37

(Licensed Software AP).

3) NETWORK TYPE (PPPOE):

This PPPOE function need to have “username” and “password” from ISP supplier.

For detailed PPPOE setting, please refer to P.36 and P.37 (Licensed Software AP).

NOTE:

DHCP and PPPOE network types need to apply DDNS service to get “Hostname” to

correspond to dynamic IP address. For detailed DDNS setting, please refer to P.37.