User`s manual

1) TITLE:

Move the cursor to the title which you want to change, and press “ENTER” to

access the setting screen. Assign each channel a title (up to six characters

(letters or symbols…)), the default title is the channel number.

2) BRIG / CONT / SATU / HUE:

Adjust the Brightness/Contrast/Saturation/Hue of each channel.

The level is from 0 to 255. The default value is 128.

3) COV (COVERT):

Select “YES” to mask the selected channel which is under recording.

When this function is activated, the “COV” words will shown on the screen.

4) RECORD:

Select “YES” to enable the record function; Select “NO” to disable the record

function.

5) UP / DOWN:

Select “UP” to go to the previous page; Select “DOWN” to go the next page.

5.8 ADVANCE MENU ___DETECTION

Move the cursor to the “DETECTION”, and press ”ENTER”, then the screen will show

the following options.

DETECTION

TITLE DET AREA LS SS TS RE ALARM

01 ON SETUP 07 03 02 10 OFF

02 ON SETUP 07 03 02 10 LOW

03 ON SETUP 07 03 02 10 HIGH

04 ON SETUP 07 03 02 10 OFF

05 ON SETUP 07 03 02 10 OFF

06 ON SETUP 07 03 02 10 OFF

07 ON SETUP 07 03 02 10 OFF

08 ON SETUP 07 03 02 10 OFF

UP DOWN

NOTE:

TITLE : 6 characters (letters or symbols…).

BRIG : from 0 ~ 255, the default value is 128.

CONT : from 0 ~ 255, the default value is 128.

SATU : from 0 ~ 255, the default value is 128.

HUE : from 0 ~ 255, the default value is 128.

CONV : YES or NO.

REC : YES or NO.