User`s manual

2.2 GETTING STARTED
2.2 GETTING STARTED
9
NOTE :
When “HDD not found”
message shows up,
please refer to appendix
# 1. It may result from
the improper installation
of the HDD.
Channel Title
Available Capacity
of Internal HDDs
System Time
Under HDD
Overwrite Mode
SYSTEM INIT…
DETECTING MASTER HDD OK
DETECTING SLAVE HDD FAIL
DETECTING DISKARRAY FAIL
VERSION 1026-08-G6-04-V354-07
SYSTEM NTSC
- 507 -
1) Before using the DVR, please have the HDDs installed ready. (refer to Appendix
#1 for installation of HDDs).
2) Connect the AC power cord to power adapter and plug into an electrical outlet.
The standby LED light will turn to red.
Press the “POWER” button. The power LED will be red. It takes approximately
10 to 15 seconds to boot the system with the message : “ SYSTEM INIT... ”,
“DETECTING MASTER HDD”, “DETECTING SLAVE HDD”, “DETECTING
DISKARRAY”, and also version information, etc.
3) Before operating the DVR, please set up the system time first. (for setting
system time, please refer to “DATE” settings).