User`s manual

5.3 SWITCH N/P SYSTEM
5.3 SWITCH N/P SYSTEM
5.2 KEY LOCK
5.2 KEY LOCK
1)
1)
Key Lock On
Key Lock On:
2)
2)
Key Lock Off
Key Lock Off:
Enter the password to exit Key Lock mode.
3)
3)
Password
Password:
For the password setting, please refer to “4) PASSWORD” in the section “4.11
ADVANCE MENU_SYSTEM” at P.24.
c Press “MENU” + “ENTER” buttons on the DVR front panel to lock keys.
d Auto key lock: refer to the section “4.11 ADVANCE MENU_SYSTEM
”.
30
1) Press “ “ or “Power” button on the DVR front panel to shutdown. Then, press
and hold “►“ first, and press “ “ or “Power” to switch to PAL system.
(Press the buttons until the monitor shows video images.)
2) Press “ “ or “Power” button on the DVR front panel to shutdown . Then, press
and hold “◄“ first, and press “ “ or “Power” to switch to NTSC system.
(Press the buttons until the monitor shows video images.)
Note:
Note: Only Model 1, 2 & 5 need to be manually switched between PAL and NTSC
systems. Model 3 & 4 will automatically detect PAL/NTSC system.
5.4 R.E.T.R.
5.4 R.E.T.R.
Before activating the R.E.T.R. function, please set the detection area and activate the motion
detection function first.
There are three ways to activate the Remote Event Trigger Recording function.
1) DVR Front Panel:
Press “Menu” + “－” buttons on the DVR front panel. And R.E.T.R. function will be activated
3 / 5 / 10 minutes later. Please refer to “4.11 ADVANCE MENU_SYSTEM
”
”.
When the R.E.T.R. is activated, the red “R.E.T.R” OSD will be shown on the screen.
2) Licensed Software AP:
Press “R.E.T.R.” button on the AP control panel to activate the R.E.T.R. function
immediately.
Please refer to
Please refer to “5.6 LICENSED SOFTWARE AP
”
”
.
.
3) IR Remote Control:
Press “R.E.T.R.” button on the IR remote control to activate the R.E.T.R. function for 3 / 5 /
10 minutes later. Please refer to “4.11 ADVANCE MENU_SYSTEM
”
”
.
.
This function is only for Model 5