User`s manual

4.7 ADVANCE MENU ___DETECTION

Move the cursor to “DETECTION” and press ”ENTER”. The screen will show the following

options.

DETECTION

TITLE DET AREA LS SS TS RE ALARM

01 ON SETUP 07 03 02 10 OFF

02 ON SETUP 07 03 02 10 LOW

03 ON SETUP 07 03 02 10 HIGH

04 ON SETUP 07 03 02 10 OFF

DETECTION

DETECTION SETUP

DETECTION TIMER

1) DETECTION SETUP:

a) TITLE:

Show the camera title of each channel.

b) DET:

Select “ON” to activate the motion detection function of the selected channel.

Select “OFF” to inactivate the motion detect function of the selected channel.

c) AREA:

Press the “ENTER” button to set the detection area.

Pink blocks represent the area that is not being detected while the transparent blocks

are the areas under detection.

Press “ENTER” to confirm the

start area

Press ◄ or ► to choose the width

of the area

Press ▲ or ▼ to choose the

height of the area, and press

“ENTER” again to confirm.

Multi-detection areas

Press “－” to set the whole

area under detection

Press “＋” to set the whole

undetected