User manual

CPAT FLEX (DSG1)

3.3 Electrical Installation

The AC/DC adapter is supplied with the equipment. It is compatible with 110V/220V and

50/60 Hz power distribution networks.

3.4 Internet Connection (optional)

The DSG1 can utilize an Internet connection to read operating parameters from the CPAT

servers and to update rmware automatically. The Internet connection might also be useful

for remote diagnostics, if needed. When connected, the unit checks for new parameters or

updates every 5 minutes. Transfers amount to a few hundred kilobytes per day.

To ensure that the DSG1 can communicate with the CPAT FTP server and obtain its param-

eters and update les, you must have the following:

• DHCP enabled on the network

The DSG1’s IPv4 address is acquired through dynamic host conguration protocol (DHCP). If

no DHCP server is present on the network, the system will not be able to transmit data over

the network.

• FTP port 21 must be open

Make sure the unit can access the Internet and that le transfer protocol (FTP) port 21 is

open. Without this access, the unit will not be able to communicate with the CPAT FTP server

nor download its parameters and update les.

NOTE

It is recommended that you install the DSG1 behind a rewall, or a router with an

integrated rewall, to avoid malicious or unauthorized connections (Ref: http://