Instruction manual

Instruction manual for spiral mixer mod. CPM80-200

6.3

Spiral mixer model CPMel

The CPMEL model can control the machine functions through programmable

settings. It can also control the Water Doser and the Thermic probe according to the

settings programmed by the user.

When reading this paragraph, refer to picture 5.2 on pag.24

• Connect the feeling cable to the electric connection and turn the main on-off

switch to position “I”.

• Be sure the emergency button is not pressed.

• Be sure that the protection grid (fig. 2.1 at pag.13) is lowered onto the

bowl

6.3.1 TECHNICAL CHARACTERISTICS

Software SMDO.01a

Water inlet 1/2 "

Maximum entry water temperature 55° C

Maximum entry water pressure 5 bar

Minimum entry water pressure 1 bar

Maximum dosing 999,9 l

Dosing precision ±1%

Water delivery at 1 bar 25 l/min.

Water delivery at 5 bar 55 l/min.

Tension 12V C.A.

Frequency 50/60 Hz

Power 10 VA

6.3.2 DOSER, INSTALLATION

In case of hard water ( high percentage of calcium ) it is advisable to use a water

softner. This equipment must be programmed in order to leave a residual hardness of

approximately 5 to 10 french centigrades.

6.3.3 DOSER, INSTRUCTIONS FOR USE

• Press the button : the display 1 flashes.

• Through the buttons program the desired quantity of water, this

will appear on the display 1..

• Press the button : the valve opens automatically and the dosing starts.

• It is possible to stop water outlet in any moment pressing the button

The display will show the quantity of water discharged; it is sufficient to press the

button to finish the discharge.