Group 1/2/3 Model: 7003 9 - 36 kg Infiniti 1 3 Universal Forward-Facing Restraint System suitable for children with body weight 9 to 36 kg. Approximately for ages 9 months to 12 years. ADULT ASSEMBLY REQUIRED.
CONTENTS IMPORTANT 1 WARNING & SAFETY INSTRUCTIONS 2 PART LIST & LEGEND 4 ASSEMBLY INSTRUCTIONS 5 Group 1 To Loosen the Harness To Adjust the Heights of the Harness Straps To Fit Child Car Seat to the Vehicle Seat To Secure Child To Tighten the Harness 6 7 8 9 11 12 Group 2 To Remove the 5-Point Harness To Secure Child To Adjust the Headrest 13 14 15 16 Group 3 To Remove the Backrest To Secure Child 17 18 19 CARE & MAINTENANCE About Harness Buckle To Clean the Harness Buckle To Clean the Plast
IMPORTANT Please read all the information contained in this instruction manual carefully before using and during installation of the child car seat. For future reference, store this instruction manual in the pouch located at the back of the child car seat. This child car seat has been approved according to the latest European safety standards ECE R44/04 and is suitable for children weighing within the following range per each Group: Age* Group Body Weight of Child 1 9-18 kg 2 15-25 kg Approx.
WARNING & SAFETY INSTRUCTIONS Use this child car seat as a FORWARD-FACING SEAT only. Use this child car seat with a 3-POINT SAFETY BELT. NEVER USE A 2-POINT SAFETY BELT, as this could cause death or injury in the event of an emergency stop or collision. Children are safer when properly restrained in vehicle REAR SEAT, rather than vehicle front seat. (according to accident statistics) DO NOT use this child car seat on vehicle front seat if it is equipped with airbags.
All foldable rear seats must be locked. The backrests of the vehicle seats must always be in an upright position. Once the car seat is fitted, make sure no parts can become trapped in the doors or the seat mechanism. The hard items and the plastic parts of the child car seat must be located and installed properly during everyday use of the vehicle, to avoid being trapped by a movable seat or by a vehicle door.
PART LIST & LEGEND 11 1 12 2 20 13 14 3 15 4 16 5 6 7 21 10 17 8 9 18 10 19 2 22 23 24 7 Infiniti 1/2/3 4 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 Harness straps Velcro fastener Shoulder pads Hip straps Buckle Crotch strap Metal retainer Cushion flap Band Support seat cushion Headrest Support backrest cushion Red belt holder Belt slot Backrest Red belt guide Seat / booster seat Harness adjuster lever Harness adjuster strap Wing Armrest Protective flap Pouch (for user
ASSEMBLY INSTRUCTIONS Remove the product from the package. With the parts lying on flat, join the hooks from lower part of backrest to the seat. Rotate backrest along hinge of seat. Insert the headrest to the backrest.
Group 1 9 kg to 18 kg For children with body weight from 9 - 18 kg 5-Point Harness with support backrest & seat cushion Infiniti 1/2/3 6 Group 1
To Loosen the Harness Press the harness adjuster lever (located underneath the cover) and pull both harness straps forward at the same time. DO NOT pull from the shoulder pads. Tip: Insert a finger through the hole of the fabric cover to press.
To Adjust the Heights of the Harness Straps (Group 1) Harness straps should be correctly adjusted for optimal protection to your child. Too low Too high The harness straps of this child car seat can be adjusted into 3 different height positions, depending on the size of the child. The harness straps must lie at your child’s shoulder level or slightly above. Loosen the harness straps as far as possible. (See “To Loosen the Harness” section. Page 7) Open the protective flap at the back of the seat.
To Fit Child Car Seat to the Vehicle Seat (Group 1) Do not twist the belt in any way during the whole installation procedure. Place the child car seat facing forward on the vehicle rear seat. Pull out the whole length of the passenger seat belt such that the diagonal belt is threaded through the gap between headrest and wing of the backseat 1 while the lap belt is threaded under the armrest 2 .
While holding the buckle, tuck in the diagonal belt to the red belt guide 5 attached on the other side and thread the lap belt UNDER the armrest 6 from the same side. Then, fasten the seat belt until you hear an audible “CLICK” 7 . 5 7 6 8 Push the car seat back against the vehicle backrest and simultaneously pull the diagonal belt upwards to tighten 8 . Remove any slack in the seat belt.
To Secure Child (Group 1) Check that the harness straps are in the correct height position. If not, see “To Adjust the Heights of the Harness Straps” section. (Page 8) Press red release button on buckle and pull tongues out of buckle. Place your child into the child car seat. Pull the harness straps over the shoulders of your child. Do not twist or interchange the harness straps.
Join the buckle tongues together and insert into the buckle until you hear an audible “CLICK”. Remove any slack by tightening the harness. (See next section “To Tighten the Harness”) Make sure that the hip straps lie as low as possible over your child’s hips. “CLICK” To Tighten the Harness (Group 1) Pull harness straps to remove any slack from the lap section. Pull the harness adjuster strap until the harness lies flat and close to the child’s body.
Group 2 15 kg to 25 kg For children with body weight from 15 - 25 kg With backrest and booster seat Convert to Group 2 child car seat only when your child exceeded the maximum weight limit Infiniti 1/2/3 13 Group 2
To Remove the 5-Point Harness (Group 2) Release the child car seat from the passenger seat belt. Flip over to the back side of the child car seat. Open the protective flap at the back of seat. Detach the Velcro fastener and release the harness straps from the harness yoke. Pull these out of the belt slots and release the support backrest cushion from the backrest of the child car seat. Return and close the protective flap.
To Secure Child (Group 2) Position the child car seat inside the vehicle rear seat and place the child in the child car seat. Fasten with the vehicle 3-Point passenger seat belt by first looping the diagonal belt inside the red belt holder located on the lower part of the headrest. Make sure that the belt is fully looped inside this hole and that the belt is not twisted in any way.
To Adjust the Headrest (Group 2) Slide the headrest up or down to the correct position according to the size of your child. Check that the child is properly secured: The diagonal belt is looped INSIDE the red belt holder of the headrest on one side and runs UNDER the armrest on the buckle side. The lap belt runs UNDER both armrests. The seat belt is tightened up and not twisted. The diagonal belt is placed in the middle of the child’s shoulder.
Group 3 22 kg to 36 kg For children with body weight from 22 – 36 kg Only booster seat Convert to Group 3 child car seat only when your child exceeded the maximum weight limit, or the top of their head is higher than maximum height of the headrest.
To Remove the Backrest (Group 3) Unfasten the passenger seat belt and remove the child car seat. Fold down and lay flat the backrest. Release the backrest piece from the hinge area to remove. Store away all dismantled components, as it is obligatory to reinstall them should the car seat need to be re-used as Group 2. To reinstall, follow the instructions described above in reverse order.
To Secure Child (Group 3) Place the booster seat on the vehicle passenger seat ensuring it is firmly touching against the vehicle seat. Place your child on the booster seat. Fasten with the vehicle 3-Point passenger seat belt with the diagonal belt resting on the shoulder of the child and then thread the diagonal belt over the armrest on the buckle side. While holding the buckle, thread the lap belt under both armrests. Then, fasten the seat belt until you hear an audible “CLICK”. Pull the belts tight.
CARE & MAINTENANCE Check regularly to make sure that all important parts are in good working condition. Check that all mechanical parts are in normal operation. Do not use the child car seat if there are any damages found. Any worn out parts should be replaced before use. Do not lubricate any parts of the child car seat. To prevent damage or breakage of this child car seat, make sure it does not become trapped or loaded by heavy baggage, reclinable seats or slamming doors.
Washing Instructions of Fabric Cover Hand wash using cold water and mild soap. DO NOT: dry clean, bleach, tumble dry, iron. Wash inside out. Line dry away from direct heat or sunlight. DO NOT use the car seat without the fabric upholstery being in place. To Install the 5-Point Harness Position the support seat cushion to the seat and the support back cushion to the backrest. Align the holes on cushion to the child car seat. Prepare the 5-Point harness according to this diagram.
Loop the metal retainer from the crotch strap through the band on the cushion flap and insert with the short side into the holes on the support seat cushion and seat cover, then into the slot of the seat all the way through the bottom. Turn the metal retainer in place to lock in position. Lift the sides of the support seat cushion and insert the other two metal retainers attached to the hip straps into the holes of the seat cover and the slots on the seat all the way through the bottom.
Attach the Velcro fasteners from the back. Press the harness adjuster level and pull up the harness yoke to loosen. PULL Loop both ends of the harness straps to the harness yoke. Check that these are secured firmly. Return and close the protective flap. DO NOT twist the harness straps. Please read and follow instructions thoroughly before re-using as Group 1 car seat.
To Remove the Fabic Cover Adjust the headrest to a higher position. Detach the Velcro fasteners near the base of the headrest. Remove the headrest cover. Detach the backrest from the seat in order to remove the cover. Turn the child car seat to the back. Open the protection flap and detach the Velcro fastener near the top of the backrest. From the lower edge of the fabric cover, pull and remove from the hinge side. Then, pull the whole cover upward through the headrest side to remove.
WARRANTY Our products are covered under warranty to the original purchaser for a period of 24 months for plastic parts, etc. and 12 months for fabric components and other parts susceptible to wear and tear. The warranty period is effective from the date of original purchase and proof of original purchase is required. It is normal for fabric to discolour from sunlight and to show wear and tear after a long period of use even when used normally.
CUSTOMER SERVICE USA and Canada: service@grow-n-up.com Toll free hotline: 1-888-GNU-9898 Other countries: support@grow-n-up.com www.cozibeebi.com Cozi Beebi ® is a trademark of Grow’n Up Ltd. © 2010 Grow’n Up Ltd. All rights reserved. Tsim Sha Tsui East, Kowloon, Hong Kong. MADE IN CHINA.
