Operating Instructions and Installation Instructions

Using Chlorine System

Start-Up:

1. Let water reach 33°C (90°F).

2. Add 1 tablespoons (14 grams) of Chlorine Granules per 758 litres (200 gallons) of water.

3. Add 1 tablespoon (14 grams) of Refresh per 758 litres (200 gallons) of water.

4. Wait 24 hours and then test and balance Alkalinity and pH levels of the water using Alkalinity Increaser, pH

Up or pH Down respectively.

Note: Have jets on high speed for 1-2 minutes when adding chemicals to mix the chemicals through the water

more effectively. Circulate water using ﬁltration mode for two additional hours.

After Each Use:

1. If you have an ozonator and/or use a Silver Sentinel Filter, add 1 teaspoon (4.75 grams) of Chlorinating gran-

ules

per person to the spa water (again, this is when you get out).

2. If you do not have an ozonator and/or use a Silver Sentinel Filter, add two teaspoons (9.5 grams) of Chlorine

Granules to the spa water.

3. If you do not use your spa for 3-4 days, add 1-2 tablespoons (4.75 - 9.5 grams) of Chlorine Granules to the

spa water for maintenance purposes.

Note: Have jets on high speed each time you add Chlorine to better mix it into the water.

Weekly:

1. Test water for Alkalinity and pH. Adjust as needed.

2. Add two (2) tablespoons (28 grams) of Refresh to spa water. Leave cover open and jets on high speed for

20 minutes.

IMPORTANT: Shock signiﬁcantly reduces pH and TA. One hour after adding Refresh test and adjust pH and TA

as needed.

Using Bromine System:

Start-Up:

1. Fill ﬂoating dispenser with pucks and open setting #7.

2. Add 2 tablespoons (28 grams) of Refresh per 1000 litres (265 gallons) of water.

3. Add 2 1/2 tablespoons (35 grams) of Peak Boost per 1000 litres (265 gallons) of water, to establish a

Bromide reserve.

4. Test the Bromide level. Once bromine reads within the ideal range (3-5 ppm) turn tablet dispenser down

to 2 or 3 or more depending on bather load.

Weekly:

1. Fill ﬂoating dispenser with pucks and reset the setting if necessary.

2. Add 2 tablespoons (28 grams) of Refresh per 1000 litres (265 gallons) of water.

3. Wait at least one hour and add 1 tablespoon (14 grams) of Best Defense per 1000 litres (265 gallons)

of water.

IMPORTANT: Refresh signiﬁcantly reduces pH and TA. One hour after adding Refresh test and adjust pH and

TA as needed.

The use of Clariﬁers and Foam inhibitors are not recommended with a disposable ﬁlter.