Operating Instructions and Installation Instructions

16
During a lter cycle:
- Pump 2 & 3* run for 20 seconds, then:
- Pump 1 runs at low speed for the programmed number of hours (see below), and
- e ozonator is turned on.
*if installed
To set the lter cycle duration (please note you can press pump 1 to exit at any time without saving):
45 Minute Filter Cycle Time-Out:
If you turn on a pump, blower, or light during a lter cycle the cycle will be interrupted and will only resume
45 minutes after you (or the system) have turned the last active output o.
Press the Filter but-
ton to enter into your
ltration options. Your
display will show “Sett”
and from here you will
be able to choose your
settings.
Press your Filter button
again to display your
rst option. is is your
Filter Cycle Duration.
Use your arrow but
-
tons to select your Filter
Cycle Duration. You
can select from 0 to 6
hours.
Press your Filter button
again. Your display will
now show the settings
for your Filtration Fre
-
quency.
Use your arrow buttons to
adjust your Filtration Fre
-
quency. You can choose
from 1-4 times per day.
You can move backwards through the programming steps by pressing your
pump 3 button.
When you have reached the end of the programming options you can press
your program button one last time to exit the programming and begin
a lter cycle immediately or simply not press any further buttons to save
your new settings and start the rst ltration cycle at the designated time.
F 06
Sett
F 06
p
FF 02
FF02
p
Quick Reference Guide
PROGRAMMING THE FILTER CYCLES