Operating Instructions and Installation Instructions

15
Starting Pump 1
Press Jet 1 button to turn Pump 1 on at low speed. Press
a second time to turn Pump 1 to high speed. A third time
turns Pump 1 o. A built-in timer automatically turns
Pump 1 o after 20 minutes, unless it has been manually
deactivated.
The Pump 1 indicator lights up when Pump 1 is on at
high speed. It ashes when Pump 1 is on at low speed.
Starting Pump 2
Press the Jet 2 to turn Pump 2 on. Pressing a second time
to turn Pump 2 o. A built-in timer automatically turns
Pump 2 o after 20 minutes, unless it has been manually
deactivated rst.
The Pump 2 indicator lights up when
Pump 2 is on.
Starting Pump 3
Press the Jet 3 to turn Pump 3 on. Pressing a second time
to turn Pump 3 o. A built-in timer automatically turns
Pump 3 o after 20 minutes, unless it has been manually
deactivated rst.
Turning The Light On:
Press the Light key to turn light on. Press a second time to
turn light o. A built in timer automatically turns the light
o after 2 hours, unless it has been manually deactivated.
The “Light” icon lights up when light is on.
Automatic Water Heater Start:
When water temperature is 1ºF (0.5ºC) lower than the Set
Point, the heater will automatically turn on until water
temperature reaches Set Point plus 1oF (0.5ºC).
The “Heater” indicator lights up with the
heater is on.
Setting Water Temperature
Use Up or Down arrow key to regulate water
temperature. The temperature setting will be
displayed for 5 seconds to conrm your new
selection.
The “Set Point” symbol indicates the desired tempera-
ture, NOT the current water temperature!
Water temperature can be adjusted by 1- degree incre
-
ments from 59º to 104ºF (15º to 40ºC).
Temperature unit:
Press and hold the light button for 5 seconds to toggle
between ºF and ºC.
Standby mode:
Press and hold Jet 3 button for 5 seconds to enter standby
mode. The “stby” message is displayed and heating & lter
-
ing will be disabled for 30 minutes. Pressing any button
will exit standby.
Note: If the system is turned down while the heater is on,
Pump 1 will run for an additional 3 minutes.
Pad Lockout:
There are two modes you can choose from: Full or partial
lock. Full lock means that all keypad functions are locked.
Partial lock means that only the basic functions will remain
accessible (pumps, blower, light).
Locking your digital control pad:
Press and hold Jet 1 for 5 seconds. The display will show
“LocP”, with “P” representing partial lock. Release the but
-
ton and the keypad will be in Partial lock mode. Keep but-
ton pressed down for 5 more seconds if you want to be in
Full lock mode. The “LocF” message will then be displayed.
When control pad is locked, all automatic functions will
run as usual. If a button is pressed down, a “LocP” or “LocF”
message will be displayed for 1 second. To unlock the key
-
pad, simply press and hold Jet 1 button again for 5 seconds.
Boost Mode:
Press and hold Jet 2 button for 5 seconds to enable Boost
mode. In this mode, Pump 1 high speed and the ozonator
will run for 45 minutes. When enabled, “boo” message is
displayed. This mode is used to speed up ltration after
intensive use of the spa or to help mix chemicals just added
to the spa. Pressing any button will exit boost mode.
Quick Reference Guide