Side Burner Manual

Hose and Regulator

The Type 1 connection system has the following features:

- The system will not allow gas to flow until a positive connection has

been made.

NOTE: The cylinder control valve must be turned off before

any connection is made or removed.

- The system has a thermal element that will shut off the flow of gas in the event of a fire.

- The system has a flow limiting device which, when activated, will limit the flow of gas to 10 cubic feet

per hour.

- NEVER use side burner without leak testing this connection.

LP (Propane) Gas Supply Connection

1. The tank valve should be in the “OFF” position. If not, turn the knob

clockwise until it stops.

2. Make sure all burner valves are in the “OFF” position.

3. Always connect the gas supply regulator as follows:

Insert the regulator inlet into the tank valve and turn the coupling nut

clockwise until the coupler tightens up (see picture). Do not over

tighten the coupler. Turn the main tank valve on and turn the burner

control valves on the unit to the “HIGH” position for about 20 seconds to allow the air in the system to

purge before attempting to light the burners.

PRE-OPERATION LEAK TESTING

DANGER

1. Do not insert any tool into the valve outlet or safety relief valve. You may damage the valve and

cause a leak. Leaking propane may result in explosion, fire, severe personal injury, or death.

2. If a leak is detected at any time or you cannot stop a gas leak, immediately close pipeline valve and

call LP gas supplier or you fire department!

3. Check all gas supply fittings before each use and each time the gas supply cylinder is connected to

the regulator. Have a qualified service technician leak test the side burner any time a part of the side

burner system is replaced.

WARNING

Never attempt to attach this side burner to the self-contained LP gas system. Do not use side burner

until leak testing.

WARNING:

Always take a leak test before lighting the side burner to prevent a possible fire or

explosion. Never store a spare propane cylinder in the vicinity of this side burner, or in the vicinity of

any

other potential heat source.