Manual Guide

Cut out Dimensions Figure A

Model Cutout Dimensions Overall Dimensions

Electrical Outlets

Needed (110V)

Grills

Height Width Depth Height Width Depth Rotisserie Lights

C1CH36 12 1/2” 32 1/2" 20 1/2" 25 1/4" 35 1/2" 25 1/2" No Qty 1

Instruction for Connecting the Transformer

1. Transformer for Interior Lights - Your grill’s electrical transformer will connect to a wiring harness located

near the back of your grill and operates the hood lights inside your grill. Insert the male end of the plug

into the female end and then plug the transformer into a standard 110v outlet. If you have any questions

or concerns, please consult or use a qualified electrician.

Electrical Grounding Instructions:

• The transformer is equipped with a three-prong grounding plug for your protection against electric

shock. This plug must be inserted directly into a properly grounded three-prong receptacle. Do not cut

or remove the grounding prong from this plug.

• The transformer must be electrically grounded in accordance with local codes or, in the absence of

local codes, in accordance with the National Electrical Code, ANSI/NFPA 70-1990 or Canadian Electrical

Code, CSA C22.1.

• Do not use an extension cord to supply power to your grill. Such use may result in fire, electrical shock

or other personal injury. Do not install a fuse in the neutral or ground circuit. A fuse in the neutral or

ground circuit may result in an electrical shock hazard. Do not ground this appliance to a gas supply

pipe or hot water pipe.

Height

Minimum of 2 vents, but optimally 4 vents, per cabinet that has any sort of gas supply or

connection. Each vent must be at least 20 sq in in size and have access to outside/fresh air.

Two vents on each side will facilitate and improve airflow and ventilation.

Vent

Width

Depth