Specifications
Configuring Support for Extended Characters
Equalizer Installation and Administration Guide 55
3. Enable sticky network aggregation by selecting a sticky netmask from the pull-down menu
shown below.
Figure29 Enablingstickynetworkaggregation
4. Click the commit button.
Configuring Support for Extended Characters
By default, support for 8-bit ASCII and multibyte UTF characters in URIs is disabled; Equalizer
returns a 400 Bad Request error when a request URI contains 8-bit or multibyte characters. To
Note – If you are using two Equalizers in a failover configuration, you must set the sticky network
aggregation mask identically for both Equalizers.