Specifications

Licensing Equalizer
Equalizer Installation and Administration Guide 41
If you don’t need to license Equalizer, select Cancel to return to the modfiy system
parameters screen. Otherwise, continue with the next step.
3. If your Equalizer is already registered with Coyote Point, skip this step.
Otherwise, you must register your Equalizer before you can license it. Click on the link shown
in the screen above to register Equalizer. Follow the prompts displayed by the Registration Web
Site. You will need to copy the system ID and the system serial number shown in the license
status screen into the registration form.
4. Do one of the following:
a. If Equalizer is connected to the Internet and a DNS server is configured, click on the get
license online button to request a license online. The license server will download your
license automatically, and ask you if you want to reboot to apply the license. Select Yes to
reboot.
b. If Equalizer is not connected to the Internet or DNS is not configured, then see the section
“Requesting a License Offline” on page 41, below.
After the system comes back up, there should be no unlicensed error in the left frame. If you
licensed Envoy, the Equalizer Status screen (select Equalizer in the left frame) should show Envoy
geographic load balancing enabled.
Requesting a License Offline
If your Equalizer is not currently connected to the Internet or if DNS is not configured for
Equalizer, then you will need to request a license offline. To do this, follow this procedure:
system ID
The internal system identifier (the MAC address of your
primary network card). [Note: in previous releases, the
system ID was shown with a colon ( : ) separating each
pair of numbers.]