Owner Manual
Table Of Contents
- C1EL120SM
- Care & Maintenance……………..............6
- Warranty............................………………..9
- Parts Listings................................…..10
- Pedestal Stand……………………………….11
- Built-In Version………………………………11
- Heat Control Grids..………………………………………………………………………………………..3 years (limited
- Stainless steel ...........................…………………………………………………......................Limited Lifetime
- Operating Instructions:
- Preparing Food for the Grill
- Grilling Tips:
- Controlling Flare-ups
- To Minimize Flare-ups:
- DRIP TRAY
- HEAT CONTROL GRIDS
- Heating Element
- Stainless Steel Care and Maintenance
- Cleaning the Stainless Steel and Polishing
- Environmental Factors that can affect your Grill
- Ways to Avoid Rust on your Grill:
- How to Remove Scratches from your Stainless Steel:
- C1EL120SM Exploded Parts View
- 1. Simply remove the cooking grate and then remove the four bolts from the lower hood assembly. Once you back these four bolts all the way out (save these for the last step), the top portion of the grill will become completely free from the oven rack....
- 2. While the grill is removed from the oven rack, remove the four black feet and keep the bolts and washers for use in a future step.
- 3. There are two screws on each side of the oven rack holding the handles in place. Remove these screws. Four total. Using those screws, install the side shelves that came with the pedestal stand to the oven rack.
- 4. Place middle pole on a flat surface in the vertical position (remove the four bolts installed on the middle pole).
- 5. Next, place pedestal base upside down on top of the middle pole. Install the four bolts from step #4 securely to the pedestal base.
- 6. Once all four bolts are secured, flip the pedestal over to where it is standing up. Remove the bolts on the middle pole, place the frame on the middle pole and use the bolts to secure frame tightly to pole.
- 7. Using the four black feet from #2, secure the oven rack to the frame.
- 8. Place the entire grill into oven rack. Using the bolts from #1. Install bolts in lower hood assembly.
- 1. To make the built-in version of the C1EL120SM, you simply have to remove the cooking grate and then remove the four bolts holding the lower hood assembly in place. Once you back these four bolts all the way out, the top portion of the grill will co...
- a. Be careful, once you release these four bolts the hood will also want to come back as it is anchored to the frame you are releasing.
- 2. Pull the plug and electrical cord out from the oven rack
- 3. Once you have that done, you can put the four bolts back into the oven rack and now the grill will be ready for built-in install.
5
ceramic briquettes should be cleaned after (or before) each use.
26. Ensure the control knobs are in the “OFF” position when not in use.
27. Use only a Ground Fault Interrupter (GFI) protected circuit with this cooking appliance.
DO NOT RELY JUST ON THIS SAFETY SECTION. USE CAUTION AND COMMON SENSE AT ALL TIMES.
PLEASE READ THE REST OF THIS MANUAL CAREFULLY FOR OTHER IMPORTANT SAFETY WARNINGS.
CALIFORNIA PROPOSITION 65 - WARNING: This product can expose you to Carbon Monoxide, which is on the
list of substances known by the state of California to cause cancer, birth defects or reproductive harm. For more
information go to: www.p65warnings.ca.gov. California law requires businesses to warn customers of potential
exposure to such substances. To minimize exposure to these substances, always operate this unit according to
the Use and Care Manual, ensuring you provide good ventilation when cooking with gas.