User's Manual

DR-915 OEM DATA RADIO MODULE
___________________________________________________________________________________________
Revision A INTEGRATOR’S
GUIDE
23
0x000D = AckBack™ Retries (Valid Range = 0 - 255.)
0x000E = AckBack™ Timeout (Valid Range = 50 - 255.)
0x000F = Communications Port (Valid range = 0 is SPI port, 1 is UART)
0x0010 = Number of Repeaters in System (Valid range = 0 - 255.)
0x0100 = ESN byte #1 (least significant byte)
0x0200 = ESN byte #2
0x0300 = ESN byte #3
0x0400 = ESN byte #4 (most significant byte)
DR915RPT Address Map:
0x0001 = Channel (Valid range = 0 - 63)
0x0002 = Preamble Bytes (Valid range = 15 - 255. Default = 15. A value of less than
15
will cause improper operation.)
0x0003 = Group 1 (Valid range = 0 - 255)
0x0004 = Group 2 (Valid range = 0 - 255)
0x0005 = Baud Rate (*see below for proper settings)
0x0006 = Debug Enable (Valid range = 1 is enabled, 0 is disabled.)
0x0100 = ESN byte #1 (least significant byte)
0x0200 = ESN byte #2
0x0300 = ESN byte #3
0x0400 = ESN byte #4 (most significant byte)