User's Manual

CDR-915L OEM DATA RADIO MODULE
___________________________________________________________________________________________
Revision M INTEGRATOR’S GUIDE
6
Click on the “PC Settings” tab, then select which COM port will be used to
connect to the data radio. As shown below, COM1 thru COM4 are available.
This setting will be retained the next time the configuration program is run.
Getting Started
To configure the radio, click on appropriate tab to select the radio type being
configured. Then select the radio Communications Port. The default setting
is for asynchronous serial mode, UART (Universal Asynchronous
Receiver/Transmitter). The default baud rate is 9600 bits per second. The
interface baud rate can be set to standard values between 2400 and 57600
as shown on the following page. This mode supports 8 data bits, 1 stop bit
and no parity.