User's Manual

CDR-915L OEM DATA RADIO MODULE
___________________________________________________________________________________________
Revision M INTEGRATOR’S GUIDE
25
DR915L Repeater Address Map:
0x0001 = Channel (Valid range = 0 – 63)
0x0002 = Preamble Bytes (high byte) (Valid range = 16 - 1000. Default = 16. A value of less than 16 will cause
improper operation.)
0x0003 = Preamble Bytes (low byte)
0x0004 = Group 1 (Valid range = 0 - 255)
0x0005 = Group 2 (Valid range = 0 - 255)
0x0006 = Baud Rate (*see below for proper settings)
0x0007 = Debug Enable (Valid range = 1 is enabled, 0 is disabled.)
*Baud Rate settings for the DR915L and Repeater are as follows:
2400 baud = 215
4800 baud = 107
9600 baud = 53 (default)
14400 baud = 35
19200 baud = 26
28800 baud = 17
38400 baud = 12 (not recommended for use)
57600 baud = 8