User's Manual

DR-915L OEM DATA RADIO MODULE
___________________________________________________________________________________________
Revision I INTEGRATOR’S GUIDE
6
Click on the “PC Settings” tab, then select which COM port will be used to connect to
the data radio. As shown below, COM1 thru COM4 are available. This setting will be
retained the next time the configuration program is run.
Getting Started
To configure the radio, click on appropriate tab to select the radio type being
configured. Then select the radio Communications Port. The default setting is for
asynchronous serial mode, UART (Universal Asynchronous Receiver/Transmitter). The
default baud rate is 9600 bits per second. The interface baud rate can be set to
standard values between 2400 and 57600 as shown on the following page. This mode
supports 8 data bits, 1 stop bit and no parity.