Product Manual

INSTALLATION AND MAINTENANCE MANUAL FORM #PM-120 REV A 12/09
Page 5 of 5
For assembly drawings, parts lists, or specific repair instructions, refer to web site at www.coxreels.com
or consult factory.
Coxreels, Inc., 5865 S. Ash Ave., Tempe, Arizona, USA, 85283 Tel: [phone]
SWIVEL SEAL REPLACEMENT
• Remove inlet hose from swivel.
• Remove swivel from reel by unscrewing swivel from shaft. Disconnect hose from swivel.
• Remove retaining ring on swivel; pull out shaft from body.
• Replace the seals, lubricate and reassemble swivel.
• Fit hose to swivel then fit swivel to reel. Do not over-tighten.
• Reconnect inlet hose and test for leakage.
TROUBLE SHOOTING GUIDE
TROUBLE CAUSE REMEDY
HOSE WILL NOT FULLY RETRACT
a) Outlet nozzle, gun or tool is too heavy.
b) Spring is fatigued.
c) Field installed hose is too long.
a) Add spring tension. See "Spring Tension Adjustment".
b) Add spring tension. See "Spring Tension Adjustment".
c) Call local Distributor for correct specified hose length.
HOSE WILL NOT RETRACT AT ALL Spring has lost all tension or has possibly broken.
a) Adjust Spring Tension
b) Call local distributor for drum/spring assembly replacement.
REEL WILL NOT LATCH (APPLIES IF
EQUIPPED WITH LATCH OPTION)
a) Incorrect operation.
b) Dog spring or locking cam is broken or worn.
a) Reel latches on first, second, third or fourth "click".
After forth "click" it automatically rewinds.
b) Replace dog spring or locking cam.
FLUID LEAKS FROM SWIVEL Swivel seals are damaged or worn.
Replace swivel seals. See "Swivel Seal Replacement".
Caution: Be sure leak is not at Hose Fitting!