User`s guide

List screen. You can, however, copy programs to a VCR tape before they are erased.
For details, see “Copy a Recording to a VCR Tape” on page 25.
Can I use PIP while copying a program to my VCR?
When copying a program to a VCR, the PIP screen displays what is being copied to the
VCR. You cannot use PIP to watch another program while copying a program to a VCR,
but you can change channels in the main screen.
Can I record two programs at the same time and
watch a live program on another channel?
No. If you are recording two programs and try tuning
to another channel, the DVR displays the message
shown here. But you can watch either of the two channels you are recording, or you
can play back a recording and watch it.
If, while recording two programs, you try to tune to another channel, the DVR displays
a Channel Change Notice to let you know that you must stop a recording to change
channels. For details, see “Recording and Watching Programs” on page 20.
What happens if a sports event that I scheduled to record goes
into overtime?
The DVR cannot determine whether a live program will end at its scheduled time.
If there is a chance that the event you are recording may continue past its scheduled
time, you can allow for this uncertainty by extending the stop time on the Confirm
Recording screen.
Do my Parental Controls in the IPG carry over to DVR recordings?
Yes. If you block programs by channel or rating in the General Settings menu,
recordings of these programs also are blocked. They will be recorded, but to play them
back, you must enter your 4-digit PIN.
Can I erase part of a recording?
No. The DVR erases the entire recording.
At the end of the program playback, the DVR started playing the recording
again from the beginning. Why?
To prevent screen burn, the DVR prevents graphics and a still image from being
displayed for too long. The Playback Status screen displays when a recording ends.
If this screen is shown for 5 minutes, the DVR begins playing the recording again from
the beginning.
When the digital receiver is in Power Save mode, will the programs that I have
scheduled to record still be recorded?
Yes. Any scheduled recording will occur when the digital receiver is in Power-Save
mode. Between 1:00 a.m. and 6:00 a.m. daily, your digital receiver automatically
enters Power Save mode unless you press a key on the remote or a key on the digital
receiver front panel at least once every two hours. In Power Save mode, the
digital receiver is powered down, but all scheduled recordings still occur. When
the digital receiver enters Power Save mode, your TV displays a black screen.
Also, the digital receiver turns on all of your Parental Controls whenever you
power down the digital receiver.
31
CBS100061_CBTV-UG_SciAtl_Pages 31 10/15/10 2:21 PM