User manual

8
COWON CM2

  


󽗈
󽗈





Delete the [CM2 Blue-
tooth] device registered on
your smartphone or other
Bluetooth device and turn
o󽗈 Bluetooth.
Remove the earphones
from the cradle and turn
o󽗈 both L and R units.
Press and hold the
left and right buttons
simultaneously for 10
seconds. Then release
them.
Press and release both left
and right buttons when
the LED turns blue. Once
reset, the L unit will enter
pairing mode, and its LED
will 󽗊ash red and blue.
Turn on Bluetooth on
your smartphone or other
Bluetooth device and
select [CM2 Bluetooth L]
from the detected devices
to complete pairing and
automatically connect.
Refer to page 'Pairing & Connection' when connecting the product to a smart device for the 󽗉rst time.
If the L and R units only connect in single mode during normal dual mode operation, reset to dual mode by following the instructions
below. If it fails to reset, start again from Step ②.
 
00:10
00:10
   
O󽗈
00:0300:03
O󽗈 O󽗈