Technical data

Distribution Unit
138--118
DISTRIBUTION
UNIT
39
3647.DOC010302Edition: Sept. 05, 2005
4.2.3.3 Adjustment of the 8 output channels (12 output channels --> E10)
Each of the 8 (12) output channels can be set to 3 different interfaces.
These interfaces are: Course bus, NMEA1 and NMEA2.
With the formats NMEA1 and NMEA2 to different configurations can be adjusted, these
configurations become active after selection (to the respective output channel).
For adjustment of this configurations see sections 4.2.3.4 .
OPEN
DIP--Switch B20
B23
B22
Fig.23: DIP--Switch position to adjust the 8 (12) output channels
Procedure:
-- Switches 1, 2 and 3 of the DIP--Switch B20 into the upper position.
-- By each operation of push button B23 another channel and/or another format
referring to the selected channel is selected and displayed.
-- This adjustment has to be performed for each connected channel.
-- Each adjustment of a format has to be set by operating push button B22 (right side of
the display). Set format blinks on the display.
-- After adjustment of all connected channels, the DIP switches 1, 2 and 3 must be
switched into the “DOWN” position again.