Technical data

Distribution Unit

138--118

DISTRIBUTION

UNIT

3647.DOC010302Edition: Sept. 05, 2005

-- Push the counterpart of the earthing insert as far as the end of the cable

shield.

-- Push the earthing insert cone below the shielding against the counterpart.

Observe a shared evenly distribution of the shielding via the cone (see Fig.12).

Wall and DIN socket

Shielding

Earthing insert

-- Cone

-- Counterpart

Seal

+ Strain relief

Washer

Counter nut

Fig.12 Making the cable entry

-- Insert the earthing insert, the seal with and the washer into the cable gland, place

the counter nut on top and hand-tighten.

-- Strip the cable cores to a length of approx. 1.5cm, twist slightly and clamp on the

cable end sleeves. Connect the cable strands in the junction box as shown in the

table below. Hand-tighten the terminal screws concerned

-- Check the connection is firm by pulling lightly.