Technical data

Distribution Unit

138--118

3647.DOC010302 Edition: Sept. 05, 2005

No. Designation at the

Interface PCB E10

Remark

Fig.5/9 Terminal board L1 of the

Interface PCB

Supply voltage +24V DC for the

Interface PCB

Fig.5/10 Switch B2 Course bus/NMEA (test purpose only)

Fig.5/11 DIP--Switch B20 Einstellungen für die Distribution Unit

Fig.5/12 Push button B23 Mode selection together with DIP--

Switch B20

Fig.5/13 LED H8 Processor clock (CAN--Bus Processor)

Fig.5/14 Display

Fig.5/15 Plug B9 Connection to flash CAN bus Pro-

cessor

Fig.5/16 Push button B22 Set--Function together with

DIP--Switch B20

Fig.5/17 Plug B10 Connection to flash DV--bus Processor

Fig.5/18 Push button B11 Reset Processor (DV--bus)

Fig.5/19 LED H5 Processor clock (DV--bus Processor)

Fig.5/20 DIP--Switch B24 DV--bus adjustments (not used)

Fig.5/21 Plug B3 Connection to the I/O PCB

Fig.5/22 Switch B4 Bus resistor DV--bus

(only if the Distribution Unit is used as

an end device in a DV--bus applica-

tion)

Fig.5/23 Plug B15 Connection for LOG, Control signals

and status signals

Fig.5/24 Plug B19 Connection MINS/RoT (Input)

Fig.5/25 Plug B17 Connection DV--Bus (Output)

Fig.5/26 Plug B18 Connection Kursbus (Output)

Fig.5/27 Plug B12 Connection GPS (Input)

Fig.5/28 Plug B13 Connection Data for SEC (Input)

Fig.5/29 Plug B6 Connection CAN1--bus

Fig.5/30 Switch B31 Resistor CAN1--bus