Instruction manual

Page30
triggered by the PIR. If you already set the
Sensitivity to OFF, then the camera will only take
photos when the Time-Lapse option is on. If you
have the PIR set to LOW, NORMAL, or HIGH, the
camera will also take photos when the PIR is
triggered. To turn the Time-Lapse option on, use
the ◄ and ► buttons to choose a time option. 5-
60 seconds (in 5 second increments) and 2-60
minutes. Once you have chosen the time option
you want, press OK to save the setting. The camera
will continuously take photos in timed increments
you set. Remember, this will generate a lot of
photos and you may want to limit the number of
photos sent via MMS daily.
START-STOP: If you only want your camera to be
on during part of the day each day you can set the
Start-Stop function. The Code Black has a dual
start-stop option. Press the ▲ and ▼ buttons to
highlight the Start-Stop option. The default setting