User guide

2. Uploading Video Files to a PC
The very first time you connect the KSC52 to a PC, Windows has to recognize the KSC52, then load driver files
so it can communicate with the KSC52.
a) With both the Remote and Power slide switches in the off position, connect the KSC52 to an active USB
port on the PC. Use the short USB cable supplied with the KSC52 (a longer cable will not work):
b) Slide the KSC52 Power switch to the on position. Since this is the first time you have connected the
KSC52 to the PC, Windows will have to perform some setup. After about 5 seconds, Windows will
detect the KSC52; you will see the message Found New Hardware displayed followed by a series of
other dialog messages indicating that Windows has found and installed drivers. When this process is
complete (about 15 seconds), you can go to the Windows Start button, then select My Computer and
you should see the KSC52 appearing as if it was just another storage device, like a hard drive. It will
look like the following (Drive F on my PC):
KSC-52 Micro DVR 3 User Guide v1.3
This end
plugs
into the
PC’s USB
port