Instruction manual

6
INSTALLING THE BELT CLIP
If necessary, attach the belt clip using the two
supplied M3 x 6 mm screws (with washers).
Note: If the belt clip is not installed, its mounting
location may get hot during continuous transmission
or when left sitting in a hot environment.
Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver.
Acrylicester,whichiscontainedintheseglues,maycrackthe
transceiver’sbackpanel.
CONNECTING AN EARPHONE/ MICROPHONE
Connect an earphone/ microphone to the
phonejackonthetopofthetransceiver.
Note:Tokeepthetransceiverwaterresistant,
thephonejackcovermustremainclosed.
Phone
jackcover
3.5 mm
plug