Installation Manual

8. Attach the left and right U-Arm assemblies to the open tubes of the ccEE Pivot Arm using the spring
buttons. Use the hole that will allow the U-Arms to swing as low as possible, without hitting the ground. See
Fig 8.
Figure 8
NOTE: If your folded spa cover is too thick to fit within the U-Arms, use the ccF U-Arm Extension to widen
the arms.
Figure 9
9. Swing the U-Arms up so that they are parallel to the ground. Raise the Main Unit so that the bottom tube
of the U-Arms is level with the top of the spa without the cover. See Fig 9.