UCG
12 | Cove Customer Care 800.222.7820
Dishwasher Operation
HEIGHT-ADJUSTABLE RACK
To move the rack down:
1 Pull the empty rack out to full extension.
2 Lift the green adjustment levers on each side up and
allow the rack to move downward to the desired loca-
tion. The adjustment levers are only used to move the
rack down. Refer to the illustration below.
To move the rack up:
1 Pull the rack out to full extension.
2 Lift up on the rack above the adjustment levers.
FOLD-DOWN TINES
Some of the tines can be adjusted to accommodate a
variety of dinnerware.
To adjust the fold-down tines:
1 Pull the rack out to full extension.
2 Push and turn the green adjustment tabs to fold down
the desired tines. Refer to the illustration below.
Dishwasher Racks
RACK REMOVAL
All of the racks can be removed. If desired, the dishwasher
can be operated with any of the racks removed.
To remove the upper and middle racks:
IMPORTANT NOTE: If the middle rack is removed, the
spray nozzle must be installed before starting a cycle. Refer
to the illustration below.
1 Pull the rack out to full extension.
2 Pull out on the tab on the side of the rack clips and
remove the clips from the end of each rack glide. Refer
to the illustration below.
3 Pull the rack forward to remove.
To remove the lower rack:
1 Pull the rack out to full extension.
2 Lift up and out.
ADJUSTMENT
LEVER
ADJUSTMENT
TA B
ADJUSTMENT
LEVER
ADJUSTMENT
TA B
Height adjustment
Tine adjustment
TA B
SPRAY
NOZZLE
Rack removal
Spray nozzle installation