Owners Manual

14
|
Cove Customer Care 800.222.7820
Water Softener
For water softener models only, a salt compartment is
located at the bottom of the interior. Refer to the illustration
below.
Prior to lling the salt compartment for the rst time, ll the
compartment with water. Water does not have to be added
with subsequent rells.
When softener salt is low, “Add Salt. Enter once added,
Cancel to ignore.” appears on the display.
To add softener salt:
1 Pull the lower rack forward and if necessary, turn the
lower spray arm away from the compartment cover.
2 Turn the cover counterclockwise to remove. It is normal
for the reservoir to contain water.
3 Fill the compartment completely with dishwasher soft-
ener salt.
4 Once full, clean any excess salt from the threads of
the salt compartment, then turn the cover clockwise to
secure.
5 Run a Quick cycle.
SOFTENER SALT
COMPARTMENT
Softener salt compartment
DISHWASHER OPERATION
CAUTION
Do not add anything other than dishwasher salt to the
salt compartment.
The water softener must regenerate periodically to maintain
water quality. When necessary, the regeneration process
starts automatically before the next wash cycle (excluding
Quick and Rinse/Hold) and lasts approximately 20 minutes.
The wash cycle begins after the regeneration process is
complete. “Water softener active. Press Start” appears on
the display during the regeneration process. To continue,
touch Start and close the door.