Installation Guide

8 | Cove Customer Care 800.222.7820
7 Verify the panel is secure against the dishwasher door,
then insert a screw into each hinge to secure the bottom
of the panel. Refer to the illustration below.
8 Finger-tighten the adjustment bracket nuts.
9 Place the kickplate magnetic strike plates on the mag-
nets and remove the adhesive backing.
10 Push the kickplate panel onto the exposed adhesive.
11 Make in-and-out adjustments. Refer to the illustration
below.
12 Remove the kickplate, then wrench-tighten the bracket
nuts.
13 Reinstall the kickplate.
DOOR PANEL
Door Panel
CUSTOM PANEL MOUNTING
1 Remove the template from the dishwasher door.
2 Place the custom panel face down on a protected work
surface.
3 Position the template ush with the top and sides of the
panel, then mark and drill the holes.
4 Remove the custom panel mounting brackets from the
dishwasher by pushing in and up on each bracket. Refer
to the illustration below.
5 Use the screws provided to secure the brackets to the
panel.
6 Align the mounting pins on the door panel with the dish-
washer door slots, then push in and shift the panel down
to secure. Refer to the illustration below.
HINGE SCREW
IN-AND-OUT
ADJUSTMENT
BRACKET
NUTS
IN-AND-OUT
ADJUSTMENT
KICKPLATE
Hinge screw Custom kickplate
PANEL
MOUNTING
BRACKET
MOUNTING
PIN
Panel mounting brackets Mounting pin