Installation Guide

6 | Cove Customer Care 800.222.7820
Plumbing Requirements
Installation must comply with all applicable plumbing codes.
Any opening into the adjacent cabinet must meet the
following: the longest dimension of the opening shall not
be more than 1
1
/2" (38). The edges of the opening must be
smooth and round.
A drain line high loop is factory installed on the unit. Do not
remove the high loop clamp. If necessary, the drain tubing
can be extended by a maximum of 5'
(1.5 m).
Locate the water supply and drain in an adjacent cabinet.
Route the water supply through the shaded area shown in
the illustration below. Connect the water supply to a hot
water house supply with an easily accessible shut-off valve
between the supply and the unit.
IMPORTANT NOTE: This appliance is intended for connec-
tion to a hot water supply. The water supply cannot be
exposed to freezing temperatures.
Purge the water supply prior to nal connection to the unit.
This will remove any debris that may be present in the
tubing from installing the new water supply. Connect the
braided tubing from the unit to the house water supply with
the tting provided. Check all water supply ttings for leaks.
5
1
/2" (140)
1
1
/2"
(
38
)
2" (51)
TOE KICK
SIDE VIEW
BACK OF
OPENING
Water supply routing
SPECIFICATIONS
PLUMBING REQUIREMENTS
Water Connection 5' (1.5 m) braided tubing with
3
/8" female compression tting
Drain Connection 5' (1.5 m) corrugated tubing
Pressure 30–140 psi
(2–9.7 bar)
Max Supply Temperature 140°F (60°C)