Installation Guide

10 | Cove Customer Care 800.222.7820
INSTALLATION
LEVELING
To adjust the front, turn the leveling legs clockwise to raise
and counterclockwise to lower the unit. Refer to the illustra-
tion below.
To adjust the rear, turn the rear adjustment screw counter-
clockwise to raise and clockwise to lower the unit.
ANCHORING
Secure the unit to adjacent cabinetry using the screws
provided. Do not overtighten. Overtightening could distort
the unit causing issues with the door seal. If applicable,
secure the top of the unit to the countertop using the screws
provided.
Verify proper door closure, then install the hole plugs in each
mounting hole location. Refer to the illustration below.
Installation
INSTALLATION
For metal cabinet installations, contact Cove Customer Care
for edge protector material prior to installation.
1 Insert the unit into the opening and pull the excess elec-
trical and plumbing supplies through the access hole as
the unit is being installed.
2 Verify the plumbing and electrical supplies are not kinked
or coiled.
PLUMBING CONNECTIONS
1 Connect the drain tube following local code. The drain
connection will accommodate 1"
(25),
3
/4" (19), and
5
/8"
(16)
drain connections. The connection must be cut to t
3
/4" (19) and
5
/8" (16) connections. If connecting to a food
waste disposer, remove the knockout prior to making the
drain connection. The drain tube connection must be 20"
(508)
to 43" (1092) above the bottom of the dishwasher
leveling legs. Refer to the illustration below.
2 Connect the water connection to the water supply with
the tting provided.
REAR
ADJUSTMENT
SCREW
FRONT
LEVELING
LEG
Leveling Anchoring
20" (508)
TO
43" (1092)
DRAIN
CONNECTION
Drain connection