Design Guide

coveappliance.com | 7
Plumbing Requirements
Installation must comply with all applicable plumbing
codes.
Locate the water supply and drain within reach of the
water and drain connections, likely in an adjacent cabi-
net. If necessary, the drain tubing can be extended by a
maximum of 5'
(1.5 m). Route the water supply through the
shaded area shown in the illustration below. Connect the
water supply line to a hot water house supply with an easily
accessible shut-o valve between the supply and the unit.
The drain tube connection must be 20"
(508) to 43" (1092)
above the bottom of the dishwasher leveling legs. Refer to
the illustration below.
PLUMBING REQUIREMENTS
Water Connection 5' (1.5 m) braided tubing with
⁄" female compression fitting
Drain Connection 5' (1.5 m) corrugated tubing
Pressure 30–140 psi (2–9.7 bar)
Electrical Requirements
Installation must comply with all applicable electrical
codes.
Locate the electrical supply within reach of the power
cord, likely in an adjacent cabinet. Refer to the illustrations
below. A separate circuit servicing only this appliance is
required. A ground fault circuit interrupter (GFCI) outlet or
breaker may be required, whichever complies with local
codes.
ELECTRICAL REQUIREMENTS
Electrical Supply 115 VAC, 60 Hz
Service 15 amp dedicated circuit
Receptacle 3-prong grounding-type
Power Cord 6' (1.8 m)
E
E
ELECTRICAL
LOCATION
IN ADJACENT
CABINET
FRONT VIEW
5
1
/2" (140)
1
1
/
2
"
(
38
)
2" (51)
TOE KICK
SIDE VIEW
BACK OF
OPENING
Electrical location Electrical routing
5
1
/2" (140)
1
1
/2"
(
38
)
2" (51)
TOE KICK
SIDE VIEW
BACK OF
OPENING
20" (508)
TO
43" (1092)
DRAIN
CONNECTION
Water supply routing Drain connection
Cove Dishwashers