Installation Guide

5
8
Start with the feet
Insert the tubes of the Feet (G) into the tubes on Base (E). Secure with two
Bolts and Nuts (K).
1
Before you begin, install the batteries!
Before beginning, an adult must install fresh alkaline batteries. Here’s how:
1. Using a Phillips screwdriver (not included), remove the screw and battery compartment cover
located under the Handlebar’s board.
2. Install three (3) fresh 1.5V AA (LR6) alkaline batteries (not included) making sure the (+) and (-)
ends face the proper direction as indicated inside the battery compartment.
3. Replace the compartment cover and tighten the screw.
G
G
E
3x AA Batteries
1.5V AA/LR6
1.5V AA/LR6
1.5V AA/LR6
Time to top it off!
Insert the Handlebar (C) into the Frame (A).
6
C
A
WAIT!
Make sure the clamp on the
Frame (A) is opened before
inserting the Handlebar (C).
Turn the knob to loosen
the clamp if needed.
Add the seat to the frame
Insert the Seat Post (D) into the Frame (A).
7
WAIT!
Make sure the clamp on the
Frame (A) is opened before
inserting the Seat Post (E).
Turn the knob to loosen
the clamp if needed.
A
D
K
x2
C
Move the switch to change the
language between English (ENG),
Spanish (SPA) and French (FR).