Start Guide ICR-2031, ICR-2431, ICR-2432, ICR-2531, ICR-2631
Start Guide Safety Instructions Please take care to following instructions: • Use the router in compliance with national and international law and in compliance with any special or additional restrictions regulating the use of the router in the various applications and environments. • To avoid possible injury and/or damage to the device, observe the relevant provisions and standards. Use only the original accessories as recommended.
Start Guide Product Disposal Instructions The WEEE (Waste Electrical and Electronic Equipment: 2012/19/EU) directive was introduced to ensure that electrical/electronic products are recycled using the best available recovery techniques in order to minimize impact on the environment. This product contains high-quality materials and components which can be recycled. At the end of it’s life this product MUST NOT be mixed with other commercial waste for disposal. The device contains the battery.
Start Guide First Use Before applying power to the router, connect all the components that you need for your applications. Do not run the router without an antenna connected to the main antenna connector as the energy from the transmission is effectively reflected by the open end and can damage the equipment. 1. Antenna Use an SMA connectors to connect the antennas to the router, see the figure below. Connect the main antenna to the ANT connector.
Start Guide 2. SIM Card The SIM card reader for one or two, depending on the product type, Micro SIM cards (3FF with size of 15.0 x 12.0 x 0.76 mm) is located on the right panel of the router under a metal cover. If you intend to use this device to communicate over a cellular network, please place an activated data-provisioned SIM card into the SIM card reader. Push your SIM card into the SIM slot until it clicks into place. Disconnect the router from the power supply before handling the SIM card.
Start Guide 3. Power The router requires an external DC power supply. The DC voltage required is between +9 and +48 V DC. The router has built-in protection against reverse polarity without signaling. Connect the power supply cable to the PWR connector on the left panel of the router (see the figure below) and tighten the locking screws. 4. Ethernet For an initial configuration, made in a web browser, connect a PC by an Ethernet cable to the default LAN interface, use the ETH0 port, see the figure above.
Start Guide Configuration 1. Configuring the Device Using the Web Browser You can use a web browser running on your PC to get access to the router web interface. Here you can perform router monitoring, configuration, and administration. First, connect the PC to the default LAN interface as described in the Ethernet chapter. To get the router interface, enter the https://192.168.1.1 address in a web browser. Please note that usage of the HTTPS protocol for secure communication over the network is required.
Start Guide 3. Restoring and Backing up the Router Configuration If you reset the router, the current configuration will be replaced by the default factory settings. We recommend you to back up the router configuration before resetting the device. Refer to the configuration manual for more information. Once the router boots up and the PWR LED starts blinking, you can restore the default button on the front panel of the router for router configuration. To do so, press the reset more than 4 seconds.
