Tus neeg siv phau ntawv

6. Insert the new battery pack all the way into the
slot
7. Put the battery pack cover back
8. Slide the battery latch to the locked position
Cleaning and Disinfecting
During normal use of the AIM tablet the device may
become dirty and should be regularly cleaned.
Steps:
1. Turn off the AIM-78S and unplug the power
cord.
2. Wipe the screen and exterior with a soft, damp
cloth moistened only with water. Do not use liquid or
aerosol cleaners on the screen, as these will discolor the
finish and damage the screen.
3. Clean the LCD display only with a soft cloth
dampened with 60% above isopropyl alcohol or 60%
above ethyl alcohol each time after use.
Do not immerse or rinse the AIM tablet or its peripherals.
If you accidentally spill liquid on the device, disconnect
the unit from the power source. Contact your IT support
department regarding the continued safety of the unit
before placing it back in operation-Do not spray cleaning
agent on the chassis.
Do not use disinfectants that contain phenol.
Do not autoclave or clean the AIM Tablet or its
peripherals with strong aromatic, chlorinated, ketone,
ether, or ether solvents, sharp tools or abrasives. Never
immerse electrical connectors in water or other liquids.
Operating Principle
The device provides input through touch panel, hard
keys located at the bottom of it, accessories through
USB ports or its LAN/WLAN connections. The device
computes the input data with its processing unit and
then output the generated data to LCD panel,
accessories or other devices through its I/O ports or
through its LAN/WLAN connections. The device is able
to store data in its storage, and when the device is
turned off, still maintain the data in the memory units of
the storage.
Connecting the Power Cord
The AIM tablet can be powered by AC/DC power
adapter. Be sure to always handle the power cords by
holding the plug ends only.
Follow these procedures in order:
1. Connect the DC plug of the power adapter to AIM
tablet product DC in connector. (Step 1)
2. Connect the 2 pin male plug of the power cord to an
electrical outlet. (Step 2)
Disposing of Old Products
Within the European Union
EU-wide legislation, as
implemented in each
member state, requires that
waste electrical and
electronic products carrying
the mark shown at left must
be disposed of separately
from normal household
waste. This includes
monitors and electrical accessories, such as signal
cables or power cords. When you need to dis-pose
of your display products, please follow the guidance
of your local authority, or ask the shop where you
purchased the product, or if applicable, follow any
agreements made between you and the provider.
The mark on electrical and electronic products only
applies to the current European Union Member
States.
Declaration of Conformity
CE Conformity Statement
Radio products with the CE alert marking comply with
the RED Directive (2014/53/EU) issued by the
Commission of the European Community. Compliance
with this directive implies conformity to the following
European Norms (in brackets are the equivalent
international standards).
• EN 62368-1 (IEC62368-1) - Product Safety
• EN 300 328 Technical requirement for radio equipment
• EN 301 893 Technical requirement for radio equipment
• ET S301 489 General EMC requirements for radio
equipment
Products that contain the radio transmitter are labeled
with CE alert marking and may also carry the CE logo.
FCC Compliance Statement
Caution!
Attention!