Technical data

76
INTELLIGENT VENTILATION
AML & AMP
SERIES
HORIZONTAL MODEL
Intake and exhaust pass horizontally out of the unit
and through an outer wall. A louvred grille is mounted
on the facade side.
VERTICAL MODEL
Intake and exhaust pass vertically up through the roof.
Roof caps and covers are used to terminate the duct.
Floor-mounted units
can be placed along
a wall, away from a
wall or freestanding,
e.g. as a room divider.
This floor-mounted unit can be
placed against a wall and inlet at
ground level (displacement ) or at
ceiling level (mixed).
Available as either a horizontal or
vertical model.
Both series consist of a range
of decentralised ventilation
units, which are particularly
suited to commercial buildings
and institutions.
CHOOSING THE RIGHT UNIT
The AML and AMP series are wall or floor
mounted ventilation units. Both come in two
models: horizontal and vertical, which indica-
tes how the intake and exhaust are placed.
Both models permit air supply through the
upper, middle or lower panels. Consequently,
1/3rd or 2/3rds of the unit can be integrated
above a ceiling.
WALLMOUNTED
FLOORMOUNTED
UNIT
VERTICAL MODEL
Vertical model with 2/3rd of the unit
integrated into a ceiling.
VERTICAL MODEL
Vertical model with 1/3rd of the unit
integrated into a ceiling.
HORIZONTAL MODEL
Horizontal model with 2/3rds of the unit
integrated into a ceiling.
HORIZONTAL MODEL
Horizontal model with 1/3rd of the unit
integrated into a ceiling.
HORIZONTAL MODEL
Intake and exhaust pass horizontally
through an outer wall.
VERTICAL MODEL
Intake and exhaust pass vertically
up through the roof.
HORIZONTAL MODEL
Intake and exhaust pass
horizontally through an outer wall.
VERTICAL MODEL
Intake and exhaust pass
vertically through the roof.
WALLMOUNTED AND PARTIALLY INTEGRATED