Use and Care Manual
9
ENGLISH
FRANÇAIS
ESPAÑOL
Operating the Juicer
The appliance will only function if all parts have been properly assembled. Proper
assembly unlocks the microswitch and allows the juicer to run.
1. Slice food into pieces just small enough to fit into the feeding tube (2). There is a
blade inside the feeding tube that will cut food in half as food is inserted.
2. Set the pulp (13) and juice containers (14) under the pulp (7) and juice (8)
spouts. Make sure the juice spout is open.
3. Switch the appliance on by turning the control knob (12) to the "ON" position.
Do not use the "R" position. This setting is for when the auger is stuck.
4. Place prepared fruits or vegetables into the feeding tube. Use the pusher to gently
press them down if they do not fall all the way in. Do not press hard on the push-
er, as this could aect the quality of the juice or cause blockage in the appliance.
Never reach into the feeding tube or place any items inside of it except for
the pusher or recommended food products.
5. The juice will flow directly into the juice jug (14), and the pulp will be collected in
the pulp container (13).
6. Aer you have processed all ingredients and the juice flow has stopped, switch the
appliance o and wait until the motor and all moving parts have stopped.
7. Empty the pulp and juice containers as needed.
8. Turn the appliance o, unplug it and then clean it using the instructions in this
guide