Technical data

70
HB EML3020 A-(en)LevelWave LR01
2.7.0 DISPLAY
2.7.1 LANGUAGE Data can be shown in any of the languages
stored in the device.
9 languages are available
in 3 packs: (1) English,
French, German and
Italian; (2) English, French,
Spanish and Portuguese;
(3) English, Chinese
(Mandarin), Japanese and
Russian
3
2.7.2 LENGTH UNIT The length unit shown in normal mode. m, cm, mm, in (inches), ft
(feet)
m
2.7.3 CONV UNIT Conversion unit. The length, volume, mass
or flow rate conversion unit for the
conversion table and shown in normal
mode.
m3, L, gal (US gallons),
ImpG (Imperial gallons),
ft3, bbl (oil barrel), kg, t,
Ston, Lton, m, cm, mm, in,
ft, m3/h, ft3/h
L
2.7.4 PSWD YES/NO If it is necessary to protect your settings in
the supervisor menu with a password, set
this menu item to YES.
YES, NO YES
2.7.5 PASSWORD This changes the password for the
supervisor menu. Push the buttons up to 6
times in any order. This will be the new
password. To confirm the change, enter the
new password a second time. For more
data, refer to Protection of the device
settings on page 75.
[>], [^], [],
[], [>] and [^]
2.7.6 CONTRAST The contrast control for the display screen.
You can select a shade of grey between
light grey (level 20) and black (level 54).
min.-max: 20…54 36
2.8.0 CONV. TABLE
2.8.1 INPUT TABLE The device uses a conversion table
(strapping table) to convert measurements
to volume, mass and flow rate readings.
The readings are shown in normal mode.
Give the number of entries on the table
(min. 2; max. 30). Select an entry (01...30)
and enter the level and the related volume /
mass / flow rate value for that entry. Push
[^] to confirm the entry values. Continue
the procedure until the device has data for
all the entries. For more data, refer to How
to configure the device to measure volume
or mass on page 78.
min. 2 entries
max. 30 entries
(level / volume, mass or
flow rate)
0 entries
2.8.2 DELETE TABLE This menu item erases the data in the
conversion table.
YES, NO NO
2.9.0 CONFIG/RESET
2.9.1 SAVE This menu item is not available. YES, NO NO
2.9.2 RECALL This menu item is not available. YES, NO NO
2.9.3 RESTART This menu item starts the device again. YES, NO NO
2.9.4 RESET FACT. If you set this menu item to "YES", the
device goes back to its initial settings (set
by the manufacturer in the factory).
YES, NO NO
1 This value is given in the customer order data
2 Units and range depend on the output function, length unit and volume unit selected
3 If the device has the LCD display option, this depends on data given in the customer order
Menu
No.
Function Function description Selection list Default