Manualshelf

Technical data

ManualsBrandsCOUNTRY FLAME TECHNOLOGIES ManualsDomestic AppliancesLR-01
41424344454647484950
48
HB EML3020 A-(en)LevelWave LR01
1 Remove the terminal compartment cover.
2 Remove the 4-pin connector.
3 Put the signal cable into the opening of the cable gland.
4 Put the electrical wires in the connector terminals. Tighten the terminal screws with a small slot-
ted-tip screwdriver. Make sure that the electrical wires agree with the terminals. For more data,
refer to the electrical schema in this section.
5 Put the connector into the 4-pin socket. Attach the Faston connector (drain wire).
6 Attach the terminal compartment cover.
7 Tighten the cable gland. Make sure that the probe housing is correctly sealed.
How to connect the signal cable to the antenna electronics
Figure 4-11: How to connect the signal cable to the antenna electronics
CAUTION!
Bending radius of the signal cable:
≥
50 mm / 2¨