Technical data

LevelWave LR01HB EML3020 A-(en)

1 Remove the terminal compartment cover.

2 Remove the 4-pin connector.

3 Put the signal cable into the opening of the cable gland.

4 Put the electrical wires in the connector terminals. Tighten the terminal screws with a small slot-

ted-tip screwdriver. Make sure that the electrical wires agree with the terminals. For more data,

refer to the electrical schema in this section.

5 Put the connector into the 4-pin socket.

6 Attach the Faston connector (drain wire).

7 Attach the terminal compartment cover.

8 Tighten the cable gland. Make sure that the remote converter is correctly sealed.

How to connect the signal cable to the remote converter

Figure 4-10: How to connect the signal cable to the remote converter

CAUTION!

Bending radius of the signal cable:

≥

50 mm / 2¨