User Manual

Bria 3 for Mac User Guide – Retail Deployments

Field Description

Headset Mode

Microphone,

Speaker

Change these fields only if you want to override the devices that Bria automatically selected.

In both these fields, select the headset you are using.

The headset is the device that is usually used for the speaker (the sound you hear) and microphone

(recording your voice). The only situation in which the headset is not used is when the Speaker

Phone button on the dialpad is pressed.

Therefore, unless you will always be using Bria in speakerphone mode, you must make a selection

here.

Select the headset in both the Speaker device field and Microphone device field.

Zero touch device

configuration

Typically, leave on. When device configuration is on, if you change your audio or video device,

Bria will automatical ly detect the new device and start using it.

Test Devices For information on the Test Devices button, see “Troubleshooting” on page 73.

Speakerphone Mode

Microphone

Speaker

Same as headset mode, but for the device to use when speakerphone is one (on the toolbar).

Select None if you do not have a speaker phone. The Speaker Phone button on the dialpad will be

disabled.

You can set different devices for the speaker and microphone: for example, you can set the speaker

to the speakerphone and set the microphone to your headset.

Other Devices

Ring on The device where you want to hear the phone ringing.

Change this field only if you want to override the devices that Bria automatically selected.

Volume The volume of the ringer.

Camera This field appears only on versions of Bria that include video functionality.

Change this field only if you want to override the devices that Bria automatically selected.

Select the camera model.

Resolution Leave at standard, or change the size as follows:

• Set it to high if you have a good camera and a computer with a f ast CPU. Yo u will know that you

have set the size too large if:

You r computer slows down (the video is using too much CPU)

The video shows black areas or is slow or jerky.

• Typically set it to low only in special situations , for example, when using wi-fi in a hotel. You

will know that you have set the size too small if the video is fuzzy.

This field is identical to the Resolution field in Medi a Quality > Video Quality.

Deskphone Setup Typically, deskphones are used only in enterprises.