User guide

FG1088-A (1S) SP-E
C. Redial
Using the handset
1. Lift up the handset, press the REDIAL button to initial a redial call
2. To end the call, place the handset back on the cradle.
Using the speakerphone
1. Press the speakerphone button. The red LED indicates the speakerphone is active,
press the REDIAL button to initial a redial call
2. To end the call, press the speakerphone again. The LED will turn off.
D. Speakerphone Volume
1. Adjust the Vol+ or Vol- button to increase or decrease the speakerphone volume.
E. Ringer Volume
1. Flip the Hi-Lo switch below the telephone body to increase or decrease the ring volume.
F. Flash
1. Press the FLASH button momentarily will enable a call transfer.
2. Press the FLASH button for a longer period of time will reactivate a dial tone to make
another call.
G. Hold
1. During conversation, press the HOLD button will place a call on hold. The opposite party
will hear music.
2. To deactivate the call on hold, press the HOLD button again.
H. Mute
1. During conversation, press the MUTE button will disable the opposite party from hearing
your conversation
2. To deactivate Mute, press the MUTE button again.
I. Programmable Memory Button
FG1088-A (1S) SP-E has up to 5 programmable memory buttons. These buttons can be used to
store commonly dial numbers or codes for activating PABX features.
Storing a number or a code
1. Lift the handset from the cradle, press the STORE button (below the faceplate), enter the
desire telephone number and press the memory button where the number going to be
stored. Replace the handset back on the cradle.